2 Assigning the VoIP LAN IP Address
The device is shipped with a factory default IP address for its operations, administration,
maintenance, and provisioning (OAMP) VoIP LAN interface, as shown in the table below:
Table 2-1: Default VoIP LAN IP Address
IP Address Value
IP Address
FXS and FXS / FXO devices: 10.1.10.10
FXO device: 10.1.10.11
Note: FXO interfaces are applicable only to MP-11x series devices.
Subnet Mask
255.255.0.0
Default Gateway IP
Address
0.0.0.0
The default IP address can be used for initially accessing the device, using any of its
management tools (i.e., embedded Web server, EMS, or Telnet). Once accessed, you can
change this default IP address to correspond with your networking scheme in which the
device is deployed. After changing the IP address, you can re-access the device with this
new LAN IP address and start configuring and managing the device as desired.
This section describes the different methods for changing the device's default IP address to
suit your networking environment:
FXS telephone voice menu - see FXS Voice Menu Guidance on page 27
2.1 Web Interface
The procedure below describes how to assign a LAN IP address using the Web interface.
To assign an IP address using the Web interface:
1. Disconnect the network cables (if connected) from the device.
2. Connect the Ethernet port located on the rear panel (labeled Ethernet) directly to the
network interface of your computer, using a straight-through Ethernet cable.
Figure 2-1: MP-11x LAN Connection to PC for Initial Connectivity
To Next Page
Loading...
Need help?
General
