MessagePolicy_MaxMessageLength,
MessagePolicy_MaxHeaderLength, MessagePoliy_MaxBodyLength,
MessagePolicy_MaxNumHeaders, MessagePolicy_MaxNumBodies,
MessagePolicy_SendRejection, MessagePolicy_MethodListType,
MessagePolicy_MethodList, MessagePolicy_BodyListType,
MessagePolicy_BodyList;
[/MessagePolicy]
Note: For a detailed description of this table, see 'Configuring SIP
Message Policy Rules'.
43.8 Coders and Profile Parameters
The profile parameters are described in the table below.
Table 43-30: Profile Parameters
Parameter Description
Coders Table / Coder Groups Table
Web: Coders
Table/Coder Group
Settings
EMS: Coders
Group
[CodersGroup0]
[CodersGroup1]
[CodersGroup2]
[CodersGroup3]
[CodersGroup4]
[CodersGroup5]
[CodersGroup6]
[CodersGroup7]
[CodersGroup8]
[CodersGroup9]
This table parameter defines the device's coders. Each group can consist of up
to 10 coders. The first Coder Group is the default coder list and the default
Coder Group.
The format of this parameter is as follows:
[ CodersGroup<0-9> ]
FORMAT CodersGroup0_Index = CodersGroup0_Name,
CodersGroup0_pTime, CodersGroup0_rate, CodersGroup0_PayloadType,
CodersGroup0_Sce;
[ \CodersGroup<0-9 ]
For example, below are defined two Coder Groups (0 and 1):
[ CodersGroup0 ]
FORMAT CodersGroup0_Index = CodersGroup0_Name,
CodersGroup0_pTime, CodersGroup0_rate,
CodersGroup0_PayloadType, CodersGroup0_Sce;
CodersGroup0 0 = g711Alaw64k, 20, 0, 255, 0;
CodersGroup0 1 = eg711Ulaw, 10, 0, 71, 0;
CodersGroup0 2 = eg711Ulaw, 10, 0, 71, 0;
[ \CodersGroup0 ]
[ CodersGroup1 ]
FORMAT CodersGroup1_Index = CodersGroup1_Name,
CodersGroup1_pTime, CodersGroup1_rate,
CodersGroup1_PayloadType, CodersGroup1_Sce;
CodersGroup1 0 = Transparent, 20, 0, 56, 0;
CodersGroup1 1 = g726, 20, 0, 23, 0;
[ \CodersGroup1 ]
Notes:
For a list of supported coders and a detailed description of this table, see
Configuring Coders on page 191.
The coder name is case-sensitive.
IP Profile Table
To Next Page
Loading...
