AudioCodes MediaPack Series MP-11x

User's Manual 474 Document #: LTRT-65417
MP-11x & MP-124
Parameter Description
[WelcomeMessage]
Enables and defines a Welcome message that appears on the
Web Login page for logging in to the Web interface.
The format of this parameter is as follows:
[WelcomeMessage ]
FORMAT WelcomeMessage_Index = WelcomeMessage_Text
[\WelcomeMessage]
For Example:
FORMAT WelcomeMessage_Index = WelcomeMessage_Text
WelcomeMessage 1 = "**********************************" ;
WelcomeMessage 2 = "********* This is a Welcome message
***" ;
WelcomeMessage 3 = "**********************************" ;
Notes:
 Each index row represents a line of text in the Welcome
message box. Up to 20 lines (or rows) of text can be defined.
 The configured text message must be enclosed in double
quotation marks (i.e., "...").
 If this parameter is not configured, no Welcome message is
displayed.
43.2.3 Telnet Parameters
The Telnet parameters are described in the table below.
Table 43-12: Telnet Parameters
Parameter Description
Web: Embedded Telnet Server
EMS: Server Enable
[TelnetServerEnable]
Enables the device's embedded Telnet server. Telnet is disabled by
default for security.
 [0] Disable (default)
 [1] Enable Unsecured
 [2] Enable Secured (SSL)
Note: Only the primary Web User Account (which has Security
Administration access level) can access the device using Telnet
(see 'Configuring Web User Accounts' on page 60).
Web: Telnet Server TCP Port
EMS: Server Port
[TelnetServerPort]
Defines the port number for the embedded Telnet server.
The valid range is all valid port numbers. The default port is 23.
Web: Telnet Server Idle
Timeout
EMS: Server Idle Disconnect
[TelnetServerIdleDisconnect]
Defines the timeout (in minutes) for disconnection of an idle Telnet
session. When set to zero, idle sessions are not disconnected.
The valid range is any value. The default value is 0.
Note: For this parameter to take effect, a device reset is required.