AudioCodes MediaPack Series MP-11x

Version 6.6 271 MP-11x & MP-124
User's Manual 25. Analog Gateway
Parameter Description
the Tel to IP Routing (see 'Configuring Tel to IP Routing' on page 223).
Time for No Reply
Forward
[FwdInfo_NoReplyTime]
If you have set the 'Forward Type' for this port to No Answer, then
configure the number of seconds the device waits before forwarding the
call to the specified phone number.
25.9 Configuring Caller ID Permissions
The Caller ID Permissions table allows you to enable per port, Caller ID generation for FXS
interfaces and Caller ID detection for FXO interfaces.
Notes:
• If Caller ID permissions is not configured for a port in this table, its Caller
ID generation / detection is determined according to the global
parameter, 'Enable Call ID' in the Supplementary Services page
(Configuration tab > VoIP menu > GW and IP to IP > DTMF and
Supplementary > Supplementary Services).
• The Caller ID Permissions table can also be configured using the table ini
file parameter, EnableCallerID.
 To configure Caller ID permissions per port:
1. Open the Caller ID Permissions page (Configuration tab > VoIP menu > GW and IP
to IP > Analog Gateway > Caller ID Permissions).
Figure 25-8: Caller ID Permissions Page
2. Configure the table as required. For a description of the parameter, see the table
below.
3. Click Submit to apply your changes.
Table 25-6: Caller ID Permissions Table Parameter Description
Parameter Description
Caller ID
[EnableCallerId_IsEnabled]
Enables Caller ID generation (FXS) or detection (FXO) per port.
 [0] Disable
 [1] Enable