15 Enabling Applications
In addition to the Gateway application (i.e., IP-to-Tel and Tel-to-IP calling), the device
supports the following main application:
Stand-Alone Survivability (SAS) application
The procedure below describes how to enable these applications. Once an application is
enabled, the Web GUI provides menus and parameter fields relevant to the application.
Notes:
• This page displays the application only if the device is installed with the
relevant Software Upgrade Key supporting the application (see 'Loading
Software Upgrade Key' on page 338).
• For configuring the SAS application, see 'Stand-Alone Survivability (SAS)
Application' on page 287.
• For enabling an application, a device reset is required.
To enable an application:
1. Open the Applications Enabling page (Configuration tab > VoIP menu >
Applications Enabling submenu > Applications Enabling).
2. From the relevant application drop-down list, select Enable.
3. Save (burn) the changes to the device's flash memory with a device reset (see 'Saving
Configuration' on page 324).
To Next Page
Loading...
Need help?
General
