AudioCodes MediaPack Series MP-11x User Manual

Version 6.6 193 MP-11x & MP-124
User's Manual 18. Coders and Profiles
Coder Name Packetization Time
(msec)
Rate (kbps) Payload
Type
Silence
Suppression
G.723.1
[g7231]
30 (default), 60, 90, 120,
150
 [0] 5.3
(default)
 [1] 6.3
4
 [0] Disable
 [1] Enable
G.726
[g726]
10, 20 (default), 30, 40,
50, 60, 80, 100, 120
 [0] 16
 [1] 24
 [2] 32
(default)
 [3] 40
Dynamic (0-
127)
Default is 23
 [0] Disable
 [1] Enable
G.727 ADPCM 10, 20 (default), 30, 40,
50, 60, 80, 100, 120
16, 24, 32, 40 Dynamic (0-
127)
 [0] Disable
 [1] Enable
G.729
[g729]
10, 20 (default), 30, 40,
50, 60, 80, 100
8 18
 [0] Disable
 [1] Enable
 [2] Enable
w/o
Adaptation
s
T.38
[t38fax]
N/A N/A N/A N/A
18.2 Configuring Coder Groups
The Coder Group Settings page allows you to define up to four groups of coders (termed
Coder Groups). For each Coder Group, you can define up to 10 coders configured with
packetization time (ptime), rate, payload type, and silence suppression. The first coder in
the Coder Group table has the highest priority and is used by the device whenever
possible. If the remote side cannot use the first coder, the device attempts to use the next
coder, and so on.
Coder Groups can be used as follows:

Assigned to Tel Profiles in the Tel Profiles table (see Configuring Tel Profiles on page
194).

Assigned to IP Profiles in the IP Profiles table (see 'Configuring IP Profiles' on page
196).
Notes:
• A specific coder can be selected only once per Coder Group.
• For a list of supported coders, see 'Configuring Coders' on page 191.
• The Coder Group Settings table can also be configured using the table
ini file parameter, CodersGroup.

AudioCodes MediaPack Series MP-11x Specifications

General

Brand	AudioCodes
Model	MediaPack Series MP-11x
Category	Gateway
Language	English