26.1.2.2 Emergency State
If the UAs detect that their primary (external) proxy does not respond, they immediately
register to SAS and start routing calls to it.
Figure 26-4: SAS Redundant Mode in Emergency State (Example)
26.1.2.3 Exiting Emergency and Returning to Normal State
Once the connection with the primary proxy is re-established, the following occurs:
SAS: Ignores REGISTER requests from the UAs, forcing the UAs to switch back to
the primary proxy.
Note: This is applicable only if the 'SAS Survivability Mode' parameter is set to
'Always Emergency' (2).
26.2 SAS Routing
This section provides flowcharts describing the routing logic for SAS in normal and
emergency states.
To Next Page
Loading...
