FORMAT PhoneContext_Index = PhoneContext_Npi,
PhoneContext_Ton, PhoneContext_Context;
[\PhoneContext]
For example:
PhoneContext 0 = 0,0,unknown.com
PhoneContext 1 = 1,1,host.com
PhoneContext 2 = 9,1,na.e164.host.com
Note: For a detailed description of this table, see 'Mapping
NPI/TON to SIP Phone-Context' on page 220.
Web/EMS: Add Phone Context
As Prefix
[AddPhoneContextAsPrefix]
Determines whether the received Phone-Context parameter is
added as a prefix to the outgoing Called and Calling numbers.
[0] Disable (default)
[1] Enable
43.11 Least Cost Routing Parameters
The Least Cost Routing (LCR) parameters are described in the table below.
Table 43-60: LCR Parameters
Parameter Description
Web: Routing Rule Groups
Table
[RoutingRuleGroups]
This table parameter enables the LCR feature and configures the
average call duration and default call cost. The default call cost
determines whether routing rules that are not configured with a Cost
Group are considered as a higher or lower cost route compared to
other matching routing rules that are assigned Cost Groups.
[ RoutingRuleGroups ]
FORMAT RoutingRuleGroups_Index =
RoutingRuleGroups_LCREnable,
RoutingRuleGroups_LCRAverageCallLength,
RoutingRuleGroups_LCRDefaultCost;
[ \RoutingRuleGroups ]
Note: For a detailed description of this table, see 'Enabling LCR and
Configuring Default LCR' on page 165.
Web: Cost Group Table
EMS: Cost Group
Provisioning > Cost Group
[CostGroupTable]
This table parameter configures the Cost Groups for LCR, where each
Cost Group is configured with a name, fixed call connection charge,
and a call rate (charge per minute).
[ CostGroupTable ]
FORMAT CostGroupTable_Index =
CostGroupTable_CostGroupName,
CostGroupTable_DefaultConnectionCost,
CostGroupTable_DefaultMinuteCost;
[ \CostGroupTable ]
For example: CostGroupTable 2 = "Local Calls", 2, 1;
Note: For a detailed description of this table, see 'Configuring Cost
Groups' on page 167.
To Next Page
Loading...
