17.5 Configuring RADIUS Accounting
The the RADIUS Parameters page allows you to enable RADIUS accounting of SIP calls
by a RADIUS accounting server. The device can send the accounting messages to the
RADIUS server upon call release, call connection and release, or call setup and release.
Notes:
• For RADIUS accounting settings to take effect, you must save the
settings to flash memory with a device reset.
• For a description of the RADIUS accounting parameters, see 'RADIUS
Parameters' on page 496.
To configure RADIUS accounting:
1. Open the RADIUS Parameters page (Configuration tab > VoIP menu > SIP
Definitions submenu > RADIUS Parameters Settings).
Figure 17-2: RADIUS Accounting Parameters Page
2. Configure the parameters as required.
3. Click Submit.
To Next Page
Loading...
