AudioCodes MediaPack Series MP-11x

User's Manual 138 Document #: LTRT-65417
MP-11x & MP-124
12.5 Configuring IP Security Associations Table
The IP Security Associations Table page allows you to configure up to 20 peers (hosts or
networks) for IP security (IPSec)/IKE. Each of the entries in this table controls both Main
Mode and Quick Mode configuration for a single peer. Each row in the table refers to a
different IP destination.
Notes:
• The proposal list must be contiguous.
• You can also configure the IP Security Associations table using the table
ini file parameter IPsecSATable (see 'Security Parameters' on page 486).
 To configure the IPSec Association table:
1. Open the IP Security Associations Table page (Configuration tab > VoIP menu >
Security submenu > IPSec Association Table).
2. Click the Add button; the following dialog box appears:
Figure 12-4: IP Security Associations Table Page - Add Record Dialog Box
3. Configure the parameters, as required. For a description of the parameters, see the
table below.
4. Click Submit.
5. To save the changes to flash memory, see 'Saving Configuration' on page 324.
Table 12-5: IP Security Associations Table Configuration Parameters
Parameter Name Description