AudioCodes MediaPack Series MP-11x

User's Manual 592 Document #: LTRT-65417
MP-11x & MP-124
Parameter Description
Keypad Feature - Transfer Parameters
Note: See the description of the KeyBlindTransfer parameter for this feature.
Keypad Feature - Call Waiting Parameters
Web: Call Waiting Activate
EMS: Keypad Features CW
[KeyCallWaiting]
Defines the keypad sequence to activate the Call Waiting
option. After the sequence is pressed, a confirmation tone is
heard.
Web: Call Waiting Deactivate
EMS: Keypad Features CW Deact
[KeyCallWaitingDeact]
Defines the keypad sequence to deactivate the Call Waiting
option. After the sequence is pressed, a confirmation tone is
heard.
Keypad Feature - Reject Anonymous Call Parameters
Web: Reject Anonymous Call
Activate
EMS: Reject Anonymous Call
[KeyRejectAnonymousCall]
Defines the keypad sequence to activate the reject anonymous
call option, whereby the device rejects incoming anonymous
calls. After the sequence is pressed, a confirmation tone is
heard.
Web: Reject Anonymous Call
Deactivate
EMS: Reject Anonymous Call
Deact
[KeyRejectAnonymousCallDeact]
Defines the keypad sequence that de-activates the reject
anonymous call option. After the sequence is pressed, a
confirmation tone is heard.
43.10.9 General FXO Parameters
The general FXO and FXS parameters are described in the table below.
Table 43-55: General FXO and FXS Parameters
Parameter Description
FXS Parameters
Web: FXS Coefficient Type
EMS: Country Coefficients
[FXSCountryCoefficients]
Determines the FXS line characteristics (AC and DC)
according to USA or Europe (TBR21) standards.
 [66] Europe = TBR21
 [70] USA = (Default) United States
Note: For this parameter to take effect, a device reset is
required.
FXO Parameters
Web: FXO Coefficient Type
EMS: Country Coefficients
[CountryCoefficients]
Determines the FXO line characteristics (AC and DC)
according to USA or TBR21 standard.
 [66] Europe = TBR21
 [70] USA = (Default) United States
Note: For this parameter to take effect, a device reset is
required.
[FXODCTermination]
Defines the FXO line DC termination (i.e., resistance).
 [0] = (Default) DC termination is set to 50 Ohms.
 [1] = DC termination set to 800 Ohms. The termination
changes from 50 to 800 Ohms only when moving from
onhook to offhook.