[S=235][SID:1034099026] (lgr_psbrdex)(619) recv
<-- DIGIT(0) Ch:0 OnTime:0 InterTime:100
Direction:0 System:1 [File: Line:-1]
18:38:14. 83 : 10.33.45.72 : NOTICE:
[S=236][SID:1034099026] (lgr_flow)(620)
#0:DIGIT_EV [File: Line:-1]
18:38:14. 83 : 10.33.45.72 : NOTICE:
[S=237][SID:1034099026] (lgr_flow)(621) |
#0:DIGIT_EV [File: Line:-1]
18:38:14.958 : 10.33.45.72 : NOTICE:
[S=301][SID:1034099026] (lgr_flow)(625) |
Log Number
(lgr)(number)
Ignore this number; it has been replaced by the Message Sequence
Number (described previously).
Session ID
Automatically assigned (random), unique session identifier (session-
id / SID) number per call in the CDR of sent Syslog messages and
debug recording packets. This enables you to filter the information
(such as SIP, Syslog, and media) according to the SID. A call
session is considered either as a Tel-to-IP leg or an IP-to-Tel leg,
where each leg is assigned a unique SID.
The benefit of this unique numbering is that it enables you to filter the
information (such as SIP, Syslog, and media) according to a specific
SID.
Note: Forked legs and alternative legs share the same SID.
Message Body
Describes the message.
Timestamp
When the Network Time Protocol (NTP) is enabled, a timestamp
string [hour:minutes:seconds] is added to all Syslog messages.
37.1.1 Event Representation in Syslog Messages
The Syslog message events that the device sends are represented by unique
abbreviations. An example of an abbreviated event in a Syslog message indicating packet
loss (PL) is shown below:
Apr 4 12:00:12 172.30.1.14 PL:5 [Code:3a002] [CID:3294] [Time:
20:17:00]
The table below lists these unique event abbreviations:
Table 37-2: Syslog Error Name Descriptions
Error Abbreviation Error Name Description
AA
Invalid Accumulated Packets Counter
AC
Invalid Channel ID
AL
Invalid Header Length
AO
Invalid Codec Type
AP
Unknown Aggregation Payload Type
AR
Invalid Routing Flag Received
To Next Page
Loading...
Need help?
General
