Notes:
• For configuring Hunt Groups, see Configuring Endpoint Phone Numbers
on page 203.
• The Hunt Group Settings table can also be configured using the table ini
file parameter, TrunkGroupSettings (see 'Number Manipulation
Parameters' on page 603).
 To configure the Hunt Group Settings table:
1. Open the Hunt Group Settings page (Configuration tab > VoIP menu > GW and IP
to IP submenu > Hunt Group > Hunt Group Settings).
Figure 20-2: Hunt Group Settings Page
2. From the 'Index' drop-down list, select the range of entries that you want to edit.
3. Configure the Hunt Group as required. For a description of the parameters, see the
table below.
4. Click Submit to apply your changes.
5. To save the changes to flash memory, see 'Saving Configuration' on page 324.
Table 20-2: Hunt Group Settings Parameters Description
Parameter Description
Hunt Group ID
[TrunkGroupSettings_TrunkGro
upId]
Defines the Hunt Group ID that you want to configure.
Channel Select Mode
[TrunkGroupSettings_ChannelS
electMode]
Defines the method by which IP-to-Tel calls are assigned to the
channels of the Hunt Group.
 [0] By Dest Phone Number = The channel is selected
according to the called (destination) number. If the number is
not located, the call is released. If the channel is unavailable
(e.g., busy), the call is put on call waiting (if call waiting is
enabled and no other call is on call waiting); otherwise, the
call is released.
 [1] Cyclic Ascending = The next available channel in the
Hunt Group, in ascending cyclic order is selected. After the
device reaches the highest channel number in the Hunt
Group, it selects the lowest channel number in the Hunt
Group, and then starts ascending again.
 [2] Ascending = The lowest available channel in the Hunt
Group is selected, and if unavailable, the next higher
channel is selected.

To Next Page
Loading...
Need help?
General
