Table 22-1: Example of Tel-to-IP Source Phone Number Manipulation Rules
Parameter Rule 1 Rule 2 Rule
3
Rule 4 Rule 5 Rule 6 Rule 7 Rule 8
Src. Trunk
Group ID
* 0 1 - - - - -
Src. Trunk
Group ID
- - * 1 - * * *
Dest. Phone
Prefix
10 10 20 [5,7-9] 00 100 100 100
Source
Phone Prefix
100 100 * * * * * *
Dest. IP
Address
10.33.45.63 10.33.45.50 - domain.com 0.0.0.0 10.33.45.68 10.33.45.67 domain.com
Dest IP
Group ID
- - 1 - - - - -
IP Profile ID
1 1 - - - - - -
Cost Group
ID
Weekend Weekend_B - - - - - -
Forking
Group
- - - 1 2 1
Table 22-2: Tel-to-IP Routing Table Parameters
Parameter Description
Matching Call Characteristics
Web/EMS: Tel to IP Routing
Mode
[RouteModeTel2IP]
or after manipulation of the destination number.
 [0] Route calls before manipulation = Calls are routed before the
number manipulation rules are applied (default).
 [1] Route calls after manipulation = Calls are routed after the
number manipulation rules are applied.
Notes:
 This parameter is not applicable if outbound proxy routing is used.
 For number manipulation, see 'Configuring Source/Destination
Number Manipulation' on page 209.
Web: Src. Trunk Group ID
EMS: Source Trunk Group ID
[PREFIX_SrcTrunkGroupID]
Defines the Hunt Group from where the call is received.
Note: To denote any Hunt Group, use the asterisk (*) symbol.
Web: Dest. Phone Prefix
EMS: Destination Phone
Prefix
[PREFIX_DestinationPrefix]
Defines the prefix and/or suffix of the called (destination) telephone
number. The suffix is enclosed in parenthesis after the suffix value.
You can use special notations for denoting the prefix. For example,
[100-199](100,101,105) denotes a number that starts with 100 to 199
and ends with 100, 101 or 105. To denote any prefix, use the asterisk
(*) symbol or to denote calls without a called number, use the $ sign.
For a description of available notations, see 'Dialing Plan Notation for
Routing and Manipulation Tables' on page 405.
The number can include up to 50 digits.
To Next Page
Loading...
Need help?
General
