User's Manual 528 Document #: LTRT-65417
MP-11x & MP-124
detected on an IP-to-Tel call.
The valid range is 0 to 127. The default value is 34.
Notes:
 For mapping specific SIT tones, you can use the
SITQ850CauseForNC, SITQ850CauseForIC, SITQ850CauseForVC,
and SITQ850CauseForRO parameters.
 This parameter is applicable only to FXO interfaces.
Web/EMS: SIT Q850
Cause For NC
[SITQ850CauseForNC]
Defines the Q.850 cause value specified in the SIP Reason header that
is included in a 4xx response when SIT-NC (No Circuit Found Special
Information Tone) is detected from the TelPSTN for IP-to-Tel calls.
The valid range is 0 to 127. The default value is 34.
Notes:
 When not configured (i.e., default), the SITQ850Cause parameter is
used.
 This parameter is applicable only to FXO interfaces.
Web/EMS: SIT Q850
Cause For IC
[SITQ850CauseForIC]
Defines the Q.850 cause value specified in the SIP Reason header that
is included in a 4xx response when SIT-IC (Operator Intercept Special
Information Tone) is detected from the Tel for IP-to-Tel calls.
The valid range is 0 to 127. The default value is -1 (not configured).
Notes:
 When not configured (i.e., default), the SITQ850Cause parameter is
used.
 This parameter is applicable only to FXO interfaces.
Web/EMS: SIT Q850
Cause For VC
[SITQ850CauseForVC]
Defines the Q.850 cause value specified in the SIP Reason header that
is included in a 4xx response when SIT-VC (Vacant Circuit - non-
registe
red number Special Information Tone) is detected from the Tel for
IP-to-Tel calls.
The valid range is 0 to 127. The default value is -1 (not configured).
Notes:
 When not configured (i.e., default), the SITQ850Cause parameter is
used.
 This parameter is applicable only to FXO interfaces.
Web/EMS: SIT Q850
Cause For RO
[SITQ850CauseForRO]
Defines the Q.850 cause value specified in the SIP Reason header that
is included in a 4xx response when SIT-RO (Reorder - System Busy
Special Information Tone) is detected from the Tel for IP-to-Tel calls.
The valid range is 0 to 127. The default value is -1 (not configured).
Notes:
 When not configured (i.e., default), the SITQ850Cause parameter is
used.
 This parameter is applicable only to FXO interfaces.
[GWInboundManipulatio
nSet]
Selects the Manipulation Set ID for manipulating all inbound INVITE
messages. The Manipulation Set is defined using the
MessageManipulations parameter. By default, no manipulation is done
(i.e. Manipulation Set ID is set to -1).
[GWOutboundManipulati
onSet]
Selects the Manipulation Set ID for manipulating all outbound INVITE
messages. The Manipulation Set is defined using the
MessageManipulations parameter. By default, no manipulation is done
(i.e. Manipulation Set ID is set to -1).
Note: This parameter is used only if the Outbound Message
To Next Page
Loading...
Need help?
General
