Note: This parameter is applicable only to FXO interfaces.
Web: Hotline Dial Tone Duration
EMS: Hot Line Tone Duration
[HotLineToneDuration]
Defines the duration (in seconds) of the hotline dial tone. If no
digits are received during this duration, the device initiates a
call to a user-defined number (configured in the Automatic
Dialing table - TargetOfChannel - see Configuring Automatic
Dialing on page 266).
The valid range is 0 to 60. The default is 16.
Notes:
 This parameter is applicable to FXS and FXO interfaces.
 You can define the Hotline duration per FXS/FXO port
using the Automatic Dialing table.
Web/EMS: Reorder Tone Duration
[sec]
[TimeForReorderTone]
Defines the duration (in seconds) that the device plays a busy
or reorder tone before releasing the line. Typically, after
playing the busy or reorder tone for this duration, the device
starts playing an offhook warning tone.
The valid range is 0 to 254. The default is 0 seconds. Note
that the Web interface denotes the default value as a string
value of "255".
Notes:
 The selected busy or reorder tone is according to the SIP
release cause code received from IP.
 This parameter can also be configured in a Tel Profile.
Web: Time Before Reorder Tone
[sec]
EMS: Time For Reorder Tone
[TimeBeforeReorderTone]
Defines the delay interval (in seconds) from when the device
receives a SIP BYE message (i.e., remote party terminates
call) until the device starts playing a reorder tone to the FXS
phone.
The valid range is 0 to 60. The default is 0.
Note: This parameter is applicable only to FXS interfaces.
Web: Cut Through Reorder Tone
Duration [sec]
[CutThroughTimeForReOrderTone]
Defines the duration (in seconds) of the reorder tone played
to the Tel side after the IP call party releases the call, for the
Cut-Through feature. After the tone stops playing, an
incoming call is immediately answered if the FXS is off-
hooked.
The valid values are 0 to 30. The default is 0 (i.e., no reorder
tone is played).
Note: To enable the Cut-Through feature, use the
CutThrough (for FXS channels) parameter.
Web/EMS: Enable Comfort Tone
[EnableComfortTone]
Determines whether the device plays a comfort tone (Tone
Type #18) to the FXS/FXO endpoint after a SIP INVITE is
sent and before a SIP 18x response is received.
 [0] Disable (default)
 [1] Enable
Note: This parameter is applicable to FXS and FXO
interfaces.
[WarningToneDuration]
Defines the duration (in seconds) for which the offhook
warning tone is played to the user.
The valid range is -1 to 2,147,483,647. The default is 600.
To Next Page
Loading...
Need help?
General
