Target setpoints 1 to 8
Output limiter
Manual operation
Manual preset output
Input error preset output
Preset output
(ON in AUT, MAN, and STOP)
AUTO, MANCAS
AUTO
When sensor
burnout occurs
Normal
MAN
RUNSTOP
SP ramp rate
SP limiter
DI16PV RSP
Input type
Input unit
Input range/scale
Analog input bias
Square root extraction
Analog input filter
Input type
Input unit
Input range/scale
Analog input bias
Square root extraction
Analog input filter
10-seg. linearizer approx./bias
PV input bias
PV input filter
Output limiter
A.BS
A.FL
BS
FL
PMD An, Bn
10-seg. linearizer approx./bias
PMD An, Bn
10-seg. linearizer approx./bias
PMD An, Bn
CNT ALG
UPR, DNR TMU
SPNO SP
SPH, SPL
A.SR A.LC
UNIT
IN
RH, RL SDP SH, SL
A.BS
A.FL
A.SR A.LC
UNIT
IN
RH, RL SDP SH, SL
EPO
OH, OL
OH, OL OLMT
PO
S/R
MPON
OT
Current or
voltage pulse
Relay Current
OUTOUT RET AL3AL2AL1
Tracking
switch
PMD
OU.H OU.L
An, Bn
Split computation
10-seg. linearizer approx./bias
RET.H RET.L
PMD An, Bn
Split computation
10-seg. linearizer approx./bias
OUT retransmission output
O1RS
Target setpoint output
RTS
Alarm Tracking switch
Output terminal assignment
DI3DI2DI1
A/M
Control computation
(to Loop-1 controller)
(Current when retransmission output)
Ratio bias computation
RT RBS
Remote input filter
RFL
PV input
Cascade input
(from Loop-1 controller)
Remote auxiliary analog
input (if equipped)
Contact inputs
(from Loop-1 controller)
Cascade (OFF→ON)
Automatic (OFF→ON)
Manual (OFF→ON)
(to Loop-1 controller)
Terminal Parameter Function
Analog signal Contact signal Front panel key
Legend
Alarm 1
(PV high limit)
Alarm 2
(PV low limit)
* After the control output terminal is specified by the parameter OT,
other current output terminals can be used as retransmission output.
PV display SP display
Switch from CAS (contact ON) to AUTO (contact
OFF) at FAIL of Loop-1 controller
DI16 is equipped on models with
remote auxiliary analog input RSP
To Next Page
Loading...
Need help?
General
