Automationdirect.com prosense PPC5 Series - Operation Display Transitions in Loop Control with PV Switching and Loop Control with PV Auto-Selector; Operation Display Transitions in Loop Control with PV Switching and Loop Control with PV Auto- Selector


PPC Manual Revision 1
Chapter 4: Operation Monitoring and Control
4.1.2 Operation Display Transitions in Loop Control with PV Switching and
Loop Control with PV Auto-selector
Program Pattern Number Display (Display only)
Parameter RMS = PROG
SP Display (SP can be changed.)
OUT Display (OUT can be changed in MAN mode.)
PID Number Display (display only)
(Factory default: non-display)
SELECT Displays 1 to 5
(Displayed only when SELECT Display is registered.)
(The figure on the left is the example of
the parameter A1 (alarm-1 setpoint).)
Auxiliary analog Input Displays (display only)
PV: PV analog input,
RSP: RSP analog input (E1-terminal area)