23-25
PPC Manual Revision 1
Chapter 23: D Registers (Holding Registers)
Loop-1 SP-related Setting (D2701 to D2800)
Register
No.
Description Range and meaning of value
D2701
RMS_L1
Remote input method
COM is not displayed if the communication function
parameter is not displayed.
D2702
RFL_L1
1 to 120 s
D2703
RT_L1
Remote input ratio
SP = Remote input x RT + Remote input bias
0.001 to 9.999
D2704
RBS_L1
Remote input bias
D2705
UPR_L1
SP ramp-up rate
Used to prevent SP from changing suddenly.
Set a ramp-up rate or ramp-down rate per hour or
minute. Set a time unit using the parameter TMU.
D2706
DNR_L1
SP ramp-down rate
D2707
TMU_L1
SP ramp-rate time unit
0: HOUR (Ramp-up rate or ramp-down rate per
1: MIN (Ramp-up rate or ramp-down rate per
D2708 to D2709
D2710
SPT_L1
SP tracking selection
Tracking is performed when the mode changes
from Remote to Local. (The local setpoint keeps
D2711
PVT_L1
PV tracking selection
Causes the setpoint to keep track of the PV so the
setpoint automatically reverts to its original value at
a preset rate of change. The UPR, DNR, and TMU
are used in combination.
Operating conditions:
1
3
5
0: OFF (
1: ON (E
D2714 to D2800
To Next Page
Loading...
Need help?
General
