Automationdirect.com prosense PPC5 Series - Mounting Method; Mounting the Controller

1-4
PPC Manual Revision 1
Chapter 1: Installation and Wiring
1.2 Mounting Method
WARNING


Mounting the Controller



 

 



Bracket
(top mounting hardware)
Terminal board
Bracket
(bottom mounting hardware)
Panel
Insert a screwdriver into the
brackets to tighten the screws.
Direction to insert the
controller
Appropriate
tightening torque:
0.25 N•m
Insert the controller
into the opening at
the front of the panel.

CAUTION



