Automationdirect.com prosense PPC5 Series - 8.10 Setting Preset Output Value

8-14
PPC Manual Revision 1
8.10 Setting Preset Output Value
8.10.1 Setting Output Value in STOP Mode (Preset Output)
Description






Preset output
RUN state STOP state
Time
0%
50%
100%
Control output
Point where the controller
enters STOP state
The preset output (fixed) applies
according to the preset output.
Control output obtained by
computation based on
deviation between SP and PV.
Setting Details
Parameter
symbol
Name
Display
level
Setting range Menu symbol
PO
 




PIDN
   
PIDG.
   


Note





Chapter 8: Output Setting Functions