Automationdirect.com prosense PPC5 Series - 1.3 External Dimensions and Panel Cutout Dimensions

1-5
PPC Manual Revision 1
Chapter 1: Installation and Wiring
1.3 External Dimensions and Panel Cutout Dimensions
Mounting the Controller

Unit: mm
(approx. inch)
Normal tolerance:
±(value of JIS B 0401-1998 tolerance class IT18)/2
(25)
(0.98)
(53) (2.09)
[(N–1)×96+92]
+0.8
0
+0.8
0
92
+0.8
0
92
+0.8
0
92
+0.03
0
(3.62 )
+0.03
0
(3.62 )
+0.03
0
(3.62 )
+0.03
0
([(N-1)×3.78+3.62] )
65 (2.56)
20 (0.79)
11
(0.43)
94.6 (3.72) 91.6 (3.61)
105.2 (4.14)
96 (3.78)
96 (3.78)
Bracket
Bracket
Terminal cover
1 to 10 mm (0.04 to 0.39 inch) (panel thickness)
General mounting
Side-by-side close mounting
“N” stands for the number of controllers to be installed.
However, the measured value applies if N≥5. General
mounting should be used when N<5.
117 (4.61) min.
145 min.
(5.71)
