17-3
PPC Manual Revision 1
Chapter 17: Software Setting Flow and Navigation
17.2 Starting up/Exiting the Parameter Setting Software
Starting up the Parameter Setting Software
Procedure
1.
The Startup Guide window is displayed at the first startup after installing the Parameter
Setting Software and if the Use Startup Guide checkbox is checked in the Environmental
Setting window.
▪ New (with Wizard)
Enables you to set system data, set parameters, save a le, and download data to
the controller in sequence.
▪ New
Creates new parameters.
▪ Open Existing File
Enables you to open and edit an existing user le.
▪ Edit Unit Data
Enables you to read out and edit data from the controller.
▪ Tuning
Enables you to tune controller data.
▪ Monitor Registers
Monitors controller registers.
▪ Monitor Ladder Programs (not used in PPC5 controller).
▪ View at Startup
If this checkbox is checked, the Startup Guide window is displayed at the next
startup.
▪ Guide message
This section displays the description of a selected function.
To Next Page
Loading...
