Automationdirect.com prosense PPC5 Series User Manual

6-15
PPC Manual Revision 1
n
Loop Control with PV Auto-selector (2 inputs) Function Block Diagram
Target setpoints 1 to 8
COM
Output limiter
Manual operation
Manual preset output
Input error preset output
Preset output
AUTO (ON)/MAN (OFF) switch
STOP (ON)/RUN (OFF) switch
LOCALREMOTE
AUTO
When sensor
burnout occurs
Normal
MAN
RUNSTOP
SP ramp rate
SP limiter
DI16PV
Input type
Input unit
Input range/scale
Analog input bias
Square root extraction
Analog input filter
10-seg. linearizer approx./bias
PV input bias
PV input filter
Ratio bias computation
PV auto-selector (Max., Min., Ave., Diff.)
Output limiter
A.BS
A.FL
BS
FL
PMD An, Bn
10-seg. linearizer approx./bias
PMD An, Bn
10-seg. linearizer approx./bias
PMD An, Bn
PV.AS
P.UNI P.DP P.RH, P.RL
CNT ALG
UPR, DNR TMU
SPNO SP
R/L
SPH, SPL
A.SR A.LC
UNIT
IN
RH, RL
SDP
SH, SL
RSP
Input type
Input unit
Input range/scale
Analog input bias
Square root extraction
Analog input filter
A.BS
A.FL
A.SR A.LC
UNIT
IN
RH, RL
SDP
SH, SL
EPO
OH, OL
OH, OL OLMT
PO
S/R
MPON
OT
Current or
voltage pulse
Relay Current
OUTOUT RET AL3AL2AL1
PMD
OU.H OU.L
An, Bn
Split computation
10-seg. linearizer approx./bias
RET.H RET.L
PMD An, Bn
Split computation
10-seg. linearizer approx./bias
OUT retransmission output
O1RS
RET retransmission output
RTS
Alarm
Output terminal assignment
DI3DI1 DI2
A/M
Control computation
(Current when retransmission output)
No function
is assigned
to DI3 and
DI16.
PV input 1
PV input 2
Remote auciliary analog
input (if equipped)
Contact inputs
* After the control output terminal is specified by the parameter OT,
other current output terminals can be used as retransmission output.
Sensor burnout occurs when PV or RSP input burnout occurs.
However, burnout is not detected if input is not conncted.
Alarm 1
(PV high limit)
Alarm 2
(PV low limit)
Alarm 3
(PV high limit)
Terminal Parameter Function
Analog signal Contact signal Front panel key
Legend
PV display
SP display
RMS
RS-485, Ethernet (if equipped)
DI16 is equipped on models with remote
auxiliary analog input RSP
Chapter 6: Control Mode Settings

Automationdirect.com prosense PPC5 Series Specifications

General

Brand	Automationdirect.com
Model	prosense PPC5 Series
Category	Controller
Language	English