17-21
PPC Manual Revision 1
Chapter 17: Software Setting Flow and Navigation
Menu symbols and parameter symbols different from those in the controller
For menu symbols and parameter symbols, the loop number and terminal area
number are indicated like register symbols. For example, the alarm function menu is
indicated as ALRM in the controller, while it is indicated as ALRM_L1 in the software.
For the notation, refer to “D-register symbols” above.
▪
Alarm function setting parameters
In the controller, the alarm type, standby operation, energized/non-energized,
and latch settings are made using one parameter. However, they are set using one
parameter each in the software.
Message registration
Register message to be displayed on the controller.
Setup parameter menu: DI.SL
Symbol: MSG1 to MSG2
Group unit copy of parameter setting value
You can copy the setting values of SP groups (SP_L1, SP_L2) and PID groups (PID_L1,
PID_L2) within each group.
Display the parameter setting window you want to copy the setting value and click
the “Copy parameter” button.
Select (group) the copy source (one) and copy destination (s), and click OK.
To Next Page
Loading...
