17-26
PPC Manual Revision 1
Chapter 17: Software Setting Flow and Navigation
Description
Data which are uploaded at once are a user file name, system data and parameter
data. Once a password has been set, it must be entered whenever you upload,
download, or compare. The password default value is non-setting. The password can
be up to eight single-byte alphanumeric characters and is case-sensitive.
Individual data can be uploaded as follows.
▪
Click on [Communication] – [Upload Parameter Data] in the menu.
<Execute Communication window>
▪
Serial Port: A port available for a PC is automatically displayed.
▪
Stop Bit, Parity, Baud Rate, and address: Set these items according to the
controllers’ s communication conditions. Data length: xed 8 bit
▪
IP Address: Set this address according to the controller’ s IP address (for Ethernet
communication).
▪
Serial Address: Set the controller’ s RS-485 communication address if
communication is made via an Ethernet/RS-485 converter. (Not allowed to be
duplicated)
▪
Port Number: Set the port number. (Decimal Number or Hexadecimal Number)
If data is downloaded via a maintenance port, nothing is displayed in the Alarm
Generation Status in the Execute Communication window.
Note
Do not disconnect a connection cable or turn off the controller power supply during an
upload.
To Next Page
Loading...
