17-28
PPC Manual Revision 1
Chapter 17: Software Setting Flow and Navigation
Window displayed if there is mismatched data
The contents of mismatch can be output to a .csv format le. If the following
message appears during data comparison, follow the instructions of the message.
If the parameter version is dierent, data may not be properly compared.
▪ To save the data and continue the process, click [Yes].
▪ To continue the process without saving the data, click [No].
▪ To stop the process, click [Cancel].
Description
33333333333333333333
▪
Serial Port: A port available for a PC is automatically displayed.
▪
Stop Bit, Parity, Baud Rate, and address: Set these items according to the controller’
s communication conditions. Data length: xed 8 bit
▪
IP Address: Set this address according to the controller’ s IP address (for Ethernet
communication).
▪
Serial Address: Set the controller’ s RS-485 communication address if
communication is made via an Ethernet/RS-485 converter. (Not allowed to be
duplicated)
▪
Port Number: Set the port number. (Decimal Number or Hexadecimal Number)
If data is downloaded via a maintenance port, nothing is displayed in the Alarm
Generation Status in the Execute Communication window.
Note
▪ Do not disconnect a connection cable or turn off the controller power supply during data
comparison.
To Next Page
Loading...
