2-19
PPC Manual Revision 1
Chapter 2 Introduction to Unit, Key, and Display Functions
Time (minute.second) Setting

1.
2.
3.
4.
5.
Example of 17 minutes 59 seconds
Press the Left arrow key to move one digit to the left.
(press the Right arrow key to move one digit to the right.)
Press the SET/ENTER key to register the setpoint.
Display the Parameter Setting Display.
Press the SET/ENTER key to move to the setting
mode (the setpoint blinks).
Press the Up or Down arrow key to change the setpoint.
Press the Up arrow key when 5 is displayed to move one
digit to the left.
Press the Down arrow key when 0 is displayed to move
one digit to the right.
To Next Page
Loading...
Need help?
General
