Page | 81 of 105
AVR8414 Operation Manual – Rev O
Table 8 – Messages by Event
On-Screen Display
(OSD) Message
An attempt was made to disable the
system pass-code when no system pass-
An attempt was made to set the system
pass-code when then system pass-code has
SET
In an attempt to set the pass-code, the
pass-code verification failed.
NOT MATCH FIRST --
A new pass-code has been successfully set.
PASSCODE HAS BEEN
SUCCESSFULLY SET
A menu screen requires a pass-code and
the pass-code entered by the operator
does not match the previously set pass-
PLEASE TRY AGAIN
The sequence to disable pass-code entry
has been completed successfully.
PASSCODE HAS BEEN
DISABLED
Due to potential media write speed issues,
moving or copying files while record is
FILE(S) WHEN RECORD
Cancel a previously requested record or
reach-back request. For example: the
recording was queued but the stop button
was pressed prior to the de-queue of the
<REC/RBK> <#> START
De-queue a previously requested record or
reach-back request.
DEQUEUED
<REC/RBK><#> START
The video capture hardware is being
reconfigured due to a setting change
(Noise filter enable/disable).
VIDEO CAPTURE
No video packets were received for more
than 1 second. There may be a gap in the
DETECTED
DETECTED
A BIT failure was detected. Details of the
failure can be found in the Log page.
WARNING: BIT FAILURE
DETECTED
WARNING: BIT FAILURE
DETECTED
Resource is already in use. Typically occurs
when an Ethernet input is already
recording on another channel.
A recording was aborted because the
record file size did not change for 10
<REC#> ABORT!
REC<#>
To Next Page
Loading...
Need help?
General