Page | 80 of 105
AVR8414 Operation Manual – Rev O
Table 8 – Messages by Event
On-Screen Display
(OSD) Message
An attempt was made to set the DVR time
while record was active.
WHILE RECORD IS
An attempt was made to set the DVR time
while reach-back was active.
WHILE REACHBACK IS
An attempt was made to set the DVR UTC
offset while record was active.
OFFSET WHILE RECORD
An attempt was made to set the DVR UTC
offset while reach-back was active.
OFFSET WHILE
The DVR is being restored to factory
default. All settings will be set to defaults.
SYSTEM FACTORY
RESTORE
NTP Start failed: NTP already started.
NTP START FAILED: NTP
ALREADY STARTED
NTP Start failed: Time set already in
progress.
TIME SET ALREADY IN
NTP Start failed: Record in progress.
NTP START FAILED:
RECORD IN PROGRESS
NTP Start failed: Reachback in progress.
REACHBACK IN
NTP Start failed: Invalid NTP Server IP
address.
INVALID NTP SERVER IP
An attempt was made to stream a TS file to
the same IP port number as is configured
for one of the record channels.
SAME IP PORT # AS REC
The event marker could not be written to
the TS file because the event marker
insertion rate exceeded the maximum rate.
OVERRUN
OVERRUN
The fast-forward and rewind buttons have
been assigned to their normal function.
The fast-forward and rewind buttons have
been assigned to navigating between event
markers (if the TS file has event markers).
EVENTS
EVENTS
The post-reach-back target media is slow
(USB or SD) and cannot support writing of
large reach-back buffers – reach-back has
been limited to 30 seconds.
RBK<#> TO 30 SEC
RBK<#> TO 30 SEC
To Next Page
Loading...
Need help?
General