Page | 79 of 105
AVR8414 Operation Manual – Rev O
Table 8 – Messages by Event
On-Screen Display
(OSD) Message
Record failed at 2GB file overflow due to
video input not being present when new
file was supposed to start.
MAX SIZE
MAX SIZE
Record was aborted because of TS Muxer
errors – most likely because the mux rate
exceeds the maximum target disk write
ERROR
ERROR
Record file cloning is only allowed on one
channel. An attempt was made to clone a
second channel.
<STORAGE-DEVICE>
FAIL – CLONE ALREADY
On reach-back start: post reach-back target
is not a disk.
<STORAGE DEVICE>
<STORAGE DEVICE>
On reach-back start: post reach-back target
disk is not present.
<STORAGE DEVICE>
<STORAGE DEVICE>
On reach-back start: post reach-back target
disk is not ready.
<STORAGE DEVICE>
<STORAGE DEVICE>
On reach-back start: post reach-back target
disk is read-only.
<STORAGE DEVICE>
<STORAGE DEVICE>
On reach-back start: calculated bits per
second of TS stream is 0.
<STORAGE DEVICE>
<STORAGE DEVICE>
On reach-back start: post reach-back target
disk is too full.
<STORAGE DEVICE>
<STORAGE DEVICE>
A command was received to end reach-
back.
A command was received to end a
recording.
A SATA disk controller failed during a
recording to that SATA disk target. DVR is
attempting to restart the recording to next
available storage target.
RESTART
RESTART
The system detected that cached disk file
write buffers are not being written to disk
fast enough – possibly due to a slow
DETECTED
DETECTED
An attempt was made to transfer file(s)
while recording is active.
FILE(S) WHEN RECORD
To Next Page
Loading...
Need help?
General