Procedure
1. Access the remote management settings. From the XT Series web interface, select
Administrator Settings > Utilities > Remote Access > Web. From the endpoint's main
menu, select Configure > Advanced > Utilities > Remote Access > Web.
Figure 111: Configuring remote management on XT Series
2. Set the fields as described in Table 48: Configuring remote management on XT Series on
page 158.
Table 48: Configuring remote management on XT Series
Field Name Description
Web Management Select whether to allow remote management via the web interface.
HTTPS Select whether to secure the remote web connection to this device with
HTTPS. HTTPS is the secured version of the standard web browser
protocol HTTP. It secures communication between a web browser and a
web server through authentication of the web site and encrypting
communication between them.
Enable all addresses You can allow or restrict the computers permitted to access the web
interface of this device. Select Yes to enable remote access from any IP
address. Select No to restrict access from a specified range of addresses
only, defined in the Address and Subnet mask fields in this screen.
Address Specify the IP address allowed to access this device remotely over the web
(only relevant if you set the Enable all addresses field to No). This can
represent a range of addresses in conjunction with the Subnet Mask field.
Subnet Mask Turn the above Address field into a range of addresses by defining its
subnet mask. This range represents the addresses allowed to access this
device remotely over the web (only relevant if you set the Enable all
addresses field to No).
User Name,
Password
Enter the remote web access username (requires HTTPS to be set to Yes).
Table continues…
Securing your XT Series
158 Avaya Scopia
®
XT Series Deployment Guide April 2015
Comments? infodev@avaya.com
To Next Page
Loading...
Need help?
General
