Table 20: Configuring general monitor settings
Field
Name
Description
Number of
monitors
Activate the HDMI ports on the XT Codec Unit which connect to a monitor: the HD1 port
and/or the HD2 port. If you are using a 4K UHD or 2160p (3840x2160) monitor, you must
connect it to the HD1 port on the back panel. This monitor is only supported on the Avaya XT7000
Series and is only supported as the main monitor.
Figure 56: Dual monitor video layouts with presentation
• <auto > indicates the system automatically detects the number of connected monitors
(recommended).
• HD1/HD2 forces the unit to accept input only from a single monitor connected to either HD1
or HD2 . If you connect a second monitor it would appear blank when the end point is
connected to a remote system, unless you select Duplicate to HD2.
• HD1 (Menu & Video Rx) + HD2 (Present) uses both monitor connections, where the main
monitor displays system menus and remote video, while shared content is on the auxiliary
monitor. This is the default mode with two connected monitors set to <auto > .
• HD1 (Menu & Present) + HD2 (Video Rx) uses both monitor connections, with system menus
and PC content on the main monitor, while remote video is on the auxiliary monitor.
• HD1 (Present) + HD2 (Menu & Video Rx) uses both monitor connections, with system menus
and remote video on the auxiliary monitor, while shared content is on the main monitor.
Table continues…
Configuring Monitors
August 2020 Deployment Guide for Avaya XT Series 123
Comments on this document? infodev@avaya.com
To Next Page
Loading...
