Field Name Description
SIP Server 2 The second SIP server through which the endpoint registers for
calls. The endpoint uses this server if SIP Server 1 is not
available.
SIP Server 3 The third SIP server through which the endpoint registers for
calls. The endpoint uses this server if SIP Server 1 and SIP
Server 2 are not available.
SIP Username The username used to connect to the SIP server.
Authentication Name Enter a name used for authentication of the SIP server.
Authentication Password Enter the password used for authentication of the SIP server.
SIP Transport Type Select the protocol used by the SIP server:
• UDP
• TCP
• TLS
Max Bandwidth Select the maximum bandwidth of the endpoint.
Default Call Bandwidth
(Kbps)
Select the maximum bandwidth of the call managed by the
endpoint, measured in kilobytes per second (kbps).
MTU Size The size of the maximum transmission unit, measured in bytes.
Video Mode Select the video mode, according to the type of picture
displayed in the endpoint.
• Motion: Select when the displayed picture is in motion.
• Sharpness: Select when the displayed picture is stationary.
Pairing Mode Select the pairing mode for Screen Link/Mobile Link:
• Disabled
• Enable - No PIN
• Enable - Ask PIN (Manual pairing)
• Enable - Ask PIN (Always)
11. Click Apply.
Avaya Meetings Management generates an endpoint service code to be used by the XT
Series endpoint. Furthermore, the endpoint details appear, where you enter an email
address for the user to receive notification that the endpoint has been pre-provisioned.
Provisioning Avaya Room System XT Series endpoints automatically
August 2020 Deployment Guide for Avaya XT Series 91
Comments on this document? infodev@avaya.com
To Next Page
Loading...
