Aventics Marex 3D - Page 106

Troubleshooting
106 AVENTICS | Marex 3D | R417003094–BDL–001–AA
The errors in the following table are general errors
referring to the thrusters. Please refer to the
manufacturer’s documention for explanation and remedial
actions.
Source HW type Error No. Error state Text message Further information Remedial action
HW OS3D 003 Light Supply Voltaoe Unstable supply
voltage
Check cabling and
voltage
HW OS3D 004 Light Temperature Inadmissible
temperature
Check device
HW OS3D/AO 005 Light Wirebreak AO 2 Broken wire at AO2.
This error is only
relevant for 4-20mA
operation.
Check cabling
HW OS3D/AO 006 Light Wirebreak AO 3 Broken wire at AO3.
This error is only
relevant for 4-20mA
operation.
Check cabling.
Source Source type Error No. Error state Text message
THR --- 025 Warning Thr. warning (bow)
THR --- 026 Warning Thr. warning stern
THR --- 027 Light Thr. alarm (bow)
THR --- 028 Light Thr. alarm Stern
THR --- 029 Light Thr.CMC no Command
THR --- 030 Light Thr.CMC trouble DI
x.yyy No. of CAN bus (Y) and CAN-ID (zzz)
xx B/S/BS/SS = Bow/Stern/BowStarboard/SternStarboard, relevant for thruster
errors
3D_manual_R417003094_DE_EN.book Seite 106 Freitag, 30. November 2018 11:36 11