DISCOVER_SETIP Message
The DISCOVER_SETIP message is sent by the controlling PC to instruct a sensor to change its IP address, subnet mask
and default gateway. The message sent by the PC must always have the following parameters in the body portion:
Either MAC or SerialNumber or both. If both are present, the match will be performed on both fields.
IP
NetMask
Gateway
Any other parameters in the body will be ignored by the sensor.
When the sensor receives a DISCOVER_SETIP message, the following actions are performed:
1. The sensor will first compare the specified MAC address, the SerialNumber, or both, if both are present, with its own.
2a. If the above field(s) does not match the sensor's equivalent, the sensor will discard the packet.
• No reply will be generated
2b. If the match is detected:
The sensor will compare the new values with the current values
• If the new values are the same as the current values, the
sensor will discard the packet
• No further reply will be generated
The sensor will set its IP address, subnet mask and default gateway to match what is in
the packet.
• The sensor will perform only syntactic checks on the supplied
data. It will not perform gateway presence or duplicate IP
address checks.
> The change will be logged in iVu system log as a succes
> A DISCOVER_REPLY packet will be sent by the sensor
back to the request originator
> The sensor will reboot in approximately 1 second
iVu Plus TG Gen2 Image Sensor
102 www.bannerengineering.com - Tel: 763.544.3164
To Next Page
Loading...
