Figure 5. Select or deselect Unicast Connection as desired
NOTE: The minimum allowed RPI is 50 ms.
4. If the module configuration was successful, the following information should be displayed:
If the module configuration was not successful, the RSLogix 5000 software will indicate errors similar to the ones
displayed below:
•
ERROR: Assembly Instance number and/or size incorrect.
• ERROR: iVu Plus not powered up or EtherNet cable not attached.
iVu Plus TG Gen2 Image Sensor
126 www.bannerengineering.com - Tel: 763.544.3164
To Next Page
Loading...
