Default Map
Main Menu
> System > Communications > Industrial EtherNet > Map > Default
Automatically maps sensor data for each inspection. Recommended when execution order of sensor types is the same
across inspections. When inspection has multiple sensors, the first 5 sensor results will be shown starting at offset 55.
Each sensor result will occupy 20 words.
Table 34: PCCC PLC Input Registers (iVu Plus Outputs, N7 Table): DEFAULT MAP
WORD # WORD NAME Data Type
0 Input Bits ACK Register (see Input and Output Flags on page
144) 16-bit integer
1 Output Bits Register (see Input and Output Flags on page 144) 16-bit integer
2-3 Error Code 32-bit integer
4-5 Inspection Number 32-bit integer
6-7 Iteration Count 32-bit integer
8-9 Pass Count 32-bit integer
10-11 Fail Count 32-bit integer
12-13 Missed Triggers 32-bit integer
14-15 Current Inspection Time Float
16 Sensor Pass/Fail Coil 16-bit integer
17-29 reserved 16-bit integer
30-52 Inspection Name 2-Word Length + 20-Unicode chars
53-54 Frame Number 32-bit integer
55 Sensor Type ID (Sensor 1) 16-bit integer
56-74 Sensor 1 Specific Data 16-bit integer
75 Sensor Type ID (Sensor 2) 16-bit integer
76-89 Sensor 2 Specific Data 16-bit integer
95 Sensor Type ID (Sensor 3) 16-bit integer
95-114 Sensor 3 Specific Data 16-bit integer
115 Sensor Type ID (Sensor 4) 16-bit integer
116-134 Sensor 4 Specific Data 16-bit integer
135 Sensor Type ID (Sensor 5) 16-bit integer
136-154 Sensor 5 Specific Data 16-bit integer
155-170 reserved 16-bit integer
171 Command Status 16-bit integer
172 Command Response Int16 16-bit integer
173-174 Command Response Int32 32-bit integer
175-176 Command Response Float Float
177-178 Command Response Length 32-bit integer
179-228 Command Response Data 100 Byte Array
229-239 reserved 16-bit integer
NOTE: If the inspection contains more than 5 sensors, the sensor after the 5th one will not be on the
map.
Table 35: Area Sensor Type ID = 2
Sensor Specific Data Data Size
Area Count 32- bit integer
Area Range Min 32- bit integer
Area Range Max 32- bit integer
iVu Plus TG Gen2 Image Sensor
140 www.bannerengineering.com - Tel: 763.544.3164