DECS-200 Introduction i
INTRODUCTION
This instruction manual provides information about the operation and installation of the DECS-200 Digital
Excitation Control System. To accomplish this, the following information is provided:
• General Information and Specifications
• Controls and Indicators
• Functional Description
• Installation
• Maintenance
WARNING!
To avoid personal injury or equipment damage, only qualified personnel should
perform the procedures in this manual.
NOTE
Be sure that the device is hard-wired to earth ground with no smaller than 12
AWG copper wire attached to the ground terminal on the rear of the unit case.
When the DECS-200 is configured in a system with other devices, it is
recommended to use a separate lead to the ground bus from each unit.
To Next Page
Loading...
