Surfaces
Hillrom Progressa ICU Hospital Bed Instructions for Use (171528 REV 15) 89
Start Percussion and Vibration
1. Press the Pulmonary Therapy menu control on the
GCI screen.
2. Press P & V.
3. Select High, Medium, Low, or Custom.
4. Press Modify to change the position.
5. Select Left, Center, Right, or Rotation position.
6. Press back arrow.
7. Press Start to begin P&V.
If Percussion and Vibration is desired with Bed Exit on, Bed Exit must be turned on before Percussion
and Vibration is started. Only Out of Bed Mode will work during Rotation Therapy.
Stop Percussion and Vibration
1. Press the Pulmonary Therapy menu control on the GCI screen.
2. Select Percussion and Vibration.
3. Press Stop Therapies or on the GCI home screen, press Stop Therapies.
Alternatively, Percussion and Vibration Therapy will stop after the allotted time. It can also be stopped
earlier using the steps above.
If rotation therapy is on and Percussion and Vibration is started (in left, right, or center), Rotation will be
turned off automatically. Turn Rotation back on if desired.
Set Custom Settings
1. Press Custom.
2. Press the applicable setting.
3. Change the setting as applicable.
4. Press Start when all settings are correct.
To Next Page
Loading...
