Bed Frame Features
70 Hillrom Progressa ICU Hospital Bed Instructions for Use (171528 REV 15)
IV POLE SOCKETS
FRACTURE FRAME SOCKETS
The Hillrom Progressa ICU Hospital Bed comes with
four standard IV sockets. Two are located at the head
end and two are located behind the footboard at the
corners of the foot end.
To help prevent injury and/or equipment damage,
obey these warnings:
• Warning—Remove all equipment from the
foot-end equipment sockets before you put
the bed in the chair position.
• Warning—Make sure there is sufficient room
at the head-end of the bed for equipment in
the sockets when you raise the bed or go in
to the Trendelendburg/Reverse
Trendelenburg positions.
Head End
Foot End
To help prevent injury and/or equipment damage, obey these
warnings:
• Warning—Caregiver to evaluate patients for entrapment
and asphyxiation when using traction equipment.
• Warning—Follow facility protocol for lockouts of bed
controls when traction equipment is installed.
There are four locations for the traction equipment to install—two
at the head end, and one on each side of the bed near the thigh
section. Make sure to use the appropriate adapter for the traction
equipment according to the manufacturer’s instructions.
Head End
Side View
To Next Page
Loading...
Need help?
General
