Patient Controls
92 Hillrom Progressa ICU Hospital Bed Instructions for Use (171528 REV 15)
NURSE CALL
HEAD UP/DOWN CONTROL
KNEE UP/DOWN CONTROL
ROOM LIGHT
READING LIGHT
On beds equipped with the Nurse Call option, NURSE call controls for the patient are
located on the inboard side of the intermediate siderails.
To Activate
• Press the Nurse Call control.
• When the nurse station acknowledges the nurse call, the inboard indicator continuously
illuminates amber and the outboard indicator does not illuminate.
• When the nurse station communication line is open, both the inboard and the outboard indicators
continuously illuminate green.
After transport, connect the bed's Nurse Call cord to the facility communication system. Use only Hill-
Rom or Baxter communications cables for proper operation of the Nurse Call system.
The patient can raise or lower the head section by using the Head Up/Down controls.
Operation of this feature is the same as that for the caregiver control previously
described in this manual except head elevation is restricted to a maximum of 55°. The
Auto Contour feature will work from the head/up down patient controls as well.
The patient can raise or lower the knee section using the Knee Up/Down controls.
Operation of this feature is the same as that for the caregiver control previously
described in this manual.
When in the Chair Egress position, the knee controls are locked out.
The Room Light control operates the room light.
To Activate
1. Press the Room Light control.
To turn off the Room Light, press the Room Light control again.
The Read Light control operates the reading light, if present.
To Activate
1. Press the Reading Light control.
To turn off the Reading Light, press the Reading Light control again.
To Next Page
Loading...
Need help?
General
