Accessories
Hillrom Progressa ICU Hospital Bed Instructions for Use (171528 REV 15) 99
To Install
To Remove
1. Make sure the patient is not on the bed.
2. Lift the head extension up and out from the bed.
3. Install the headboard.
PRONING KIT (P7529)
• Warning—Make sure the bed brakes are set before you install or remove the proning
accessory.
• Warning—Do not exceed the 44 lb (20 kg) safe working load of the head support proning
accessory.
• Warning—Do not transport a patient with the proning accessory installed.
• Warning—Only use authorized replacement parts from Baxter.
• Warning—Do not lean, kneel, or sit on the proning accessory.
• Warning—Lock out the head and knee articulation controls when the proning accessory is in
use.
• Warning—Make sure patient’s head is correctly aligned on the foam face cushion/ head
support of the proning accessory. Monitor the position and adjust as needed once the patient is
in the prone position.
• Warning—Do not initiate any therapy modes (turn assist, rotation therapy, or any therapy that
could cause patient movement) on the bed when the proning accessory is in use.
• Warning—Make sure the integrated air surface, if applicable, is in normal mode when the
proning accessory is in use.
• Warning—Observe lines and tubes closely during patient positioning.
• Warning—Make sure the headboard is installed after the proning accessory is removed.
• Warning—Instruct conscious patients not to adjust the proning accessory without the
assistance of a caregiver.
1. Make sure the bed brakes are set and a patient is not on the
bed.
2. Remove the headboard.
3. Install the two head extension legs into the holes for traction
equipment.
The shorter head extension legs will rest on the head weldment
on the bed.
To help prevent injury and/or equipment damage, obey these
warnings:
• Warning—Before using the proning accessory with a
patient, read and understand Instructions for Use (773439).
To Next Page
Loading...
Need help?
General
