EasyManuals Logo

baxter Hillrom Progressa User Manual

baxter Hillrom Progressa
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #153 background imageLoading...
Page #153 background image
Mattress Connection Troubleshooting
Hillrom Progressa ICU Hospital Bed Instructions for Use (171528 REV 15) 141
Other Surfaces
WARNING:
WarningThe Envision E700 surface on the Hillrom Progressa ICU Hospital Bed narrow frame is not
fully compliant to the IEC 60601-2-52:2009 standard; however, it is compliant with the FDA Guidance:
Hospital Bed System Dimensional and Assessment Guidance to Reduced Entrapment [Issued March 10,
2006] standard. Use of a surface in combination with the product that is not fully compliant to the IEC
60601-2-52:2009 standard may increase the risk of patients becoming trapped. In such cases, the
patient must be monitored closely.
WARNING:
WarningThe following surfaces can be used with the Hillrom Progressa ICU Hospital Bed (narrow
bed frame only) with the Dining Chair feature option. Do not use the following surfaces with the
StayInPlace option. Do not use the FlexAfoot feature with the following surfaces (see Hillrom
Progressa and Progressa+ ICU Hospital Bed Service Manual (171748) for instructions to disable the air
surface (if applicable) and Chair Egress):
P500 MRS
NP100 Surface—flat deck 36" x 84" (91 cm x 213 cm)
AccuMax Surface—flat deck 36" x 84" (91 cm x 213 cm)
Accella Therapy MCM Surface P006788A—flat deck 36" x 84" (91 cm x 213 cm)
MATTRESS CONNECTION TROUBLESHOOTING
Message Problem Solution
Not Compatible Mattress—
Not all Progressa+ Air Mat
-
tresses will operate on some
Progressa bed frames.
For example
A wide (Xtend)
Progressa+ mattress will
not operate on a narrow
Progressa bed frame.
A StayInPlace mattress
will not operate on a non-
StayInPlace bed frame.
Install a mattress that is compati-
ble with the bed. See “P7500A
Bed Upgraded with a P7540A
Progressa+ Surface” on
page 139.
NOTE:
If the correct mattress is installed
and this error shows, contact the
facility maintenance department
for assistance.
ACB/UCB not Configured—
The air control board (ACB) or
the upper control board
(UCB) is not properly config
-
ured.
Contact your facility
maintenance person.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the baxter Hillrom Progressa and is the answer not in the manual?

baxter Hillrom Progressa Specifications

General IconGeneral
Brandbaxter
ModelHillrom Progressa
CategoryMedical Equipment
LanguageEnglish

Related product manuals