Bed Frame Features
Hillrom Progressa ICU Hospital Bed Instructions for Use (171528 REV 15) 69
The cassette should insert easily. If it does not, take action to further offload patient weight. This may
generally be accomplished by raising the head of bed angle further, requesting the patient to lean
forward, or obtaining the assistance of a second person, as appropriate for the clinical situation.
EQUIPMENT SOCKETS
To use the sleeve, do as follows:
1. Make sure the brake is set on the bed.
2. Make sure the head of the bed is at least 30°. The
position may be adjusted for patient comfort.
3. Put the mattress in the Max-Inflate/P-Max Inflate
mode:
a. Press the Surface menu control on the GCI screen.
b. Press Max-Inflate/P-Max Inflate.
4. Pull the sheet away from the edge of the mattress.
5. Lift the flap over the zipper.
6. Unzip the sleeve. Use caution when operating the
zipper. If the zipper binds, do not continue to pull.
7. Make sure the x-ray cassette is in a pillow case or
similar covering.
8. Insert the x-ray cassette.
9. Remove the x-ray cassette when finished.
10. Close and zip the sleeve.
Equipment sockets are provided at each corner of the deck for
equipment such as IV poles and infusion support.
To help prevent equipment damage, obey these cautions:
• Caution—The equipment sockets are not to be used for
overhead fracture frame equipment.
• Caution—Before moving the bed into any of the chair
positions, remove all equipment from the sockets at the
foot end of the articulating deck.
• Caution—While articulating into a Trendelenburg position, make sure there is adequate
headwall clearance.
To Next Page
Loading...
Need help?
General
