Power Conservation
112 Hillrom Progressa ICU Hospital Bed Instructions for Use (171528 REV 15)
Press the blue button on the end of the drive box to disable the battery if the bed will be stored for an
extended period of time.
After replacing the batteries, charge the batteries a minimum of 20 hours before use.
Follow instructions on the batteries for proper disposal or recycling.
Troubleshooting
Warning—Only facility-authorized personnel should troubleshoot the Hillrom Progressa ICU Hospital
Bed. Troubleshooting by unauthorized personnel could cause injury or equipment damage.
Always check the battery charge status on the siderail. The bed may not be functioning due to the
battery being drained, and the bed needing to be plugged into its appropriate power source.
POWER CONSERVATION
The Progressa Bed has the means to reduce the use of electricity. The GCI screen automatically dims to
reduce the use of electricity, and when there is no patient on the bed, the compressor will not cycle
power as often.
The bed can also be placed in a transport mode to conserve AC power.
TRANSPORTATION MODE
When the transportation mode is activated, the articulation controls are disabled on battery power.
To Activate
1. On the intermediate siderail controls, press and hold the Lockout control for approximately 10
seconds. A triple beep sounds and the Service Required indicator illuminates to let you know the
bed is in service mode.
2. On the patient controls (inside of the siderail), press and hold the Knee Up and Knee Down controls
at the same time. A click will sound to let you know the bed is in transportation mode.
To Deactivate
If the bed is unplugged from AC power, on the patient controls (inside of the siderail), press and hold the
Head Up and Head Down, and Nurse Call controls at the same time. A beep will sound to let you know
the bed is no longer in transportation mode.
or
Plug the bed to AC power and the bed will come out of Transportation Mode after 30 minutes.
To Next Page
Loading...
Need help?
General
