Accessories
98 Hillrom Progressa ICU Hospital Bed Instructions for Use (171528 REV 15)
HEAD EXTENSION (P752801/P752802/P752803)
NOTES:
• The head extension is used to position the patient’s head closer to the caregiver and is intended
to be used only during routine non-urgent procedures.
• The head extension can only be installed when the headboard is removed, the head section is
flat, and the transport handles are in the stowed position.
• The headboard must be installed on the bed when not using the head extension.
To Stow
1. Remove all equipment from the shelf, and connect the hook
and loop straps.
2. Lift the shelf up and over the footboard away from the sleep
surface until the shelf is flat against the footboard and is
locked in position.
To help prevent injury and/or equipment damage, obey these
warnings:
• Warning—Make sure the bed brakes are set and that
there is no patient on the bed before you install or
remove the head extension.
• Warning—Do not exceed the 254 lb (115 kg) safe
working load of the head extension. To do so could cause
the head extension to fail.
• Warning—Use the head extension under direct caregiver
supervision only. Remove the head extension when the
patient is to be left alone.
• Warning—Do not use the bed scale when the head extension is installed. The head
extension will cause inaccurate scale readings.
• Warning—Do not transport a patient with the head extension installed.
• Warning—Only use authorized replacement parts from Baxter.
Caution—Do not kneel or sit on the head extension. To do so could cause equipment damage.
To Next Page
Loading...
Need help?
General
