Accessories
94 Hillrom Progressa ICU Hospital Bed Instructions for Use (171528 REV 15)
INFUSION SUPPORT SYSTEM (P158A)
To help prevent personal injury or equipment damage, obey these warnings:
• Warning—Do not exceed 20 lb (9 kg) load capacity (safe working load) of the infusion support
system (ISS) pole.
• Warning—Correctly attach the ISS pole; otherwise, it may fall.
• Warning—Uneven loading of the ISS pole could cause the contents to fall.
• Warning—When you lower the upper section of an ISS pole, always grasp and hold the upper
section of the pole before pulling the release knob.
• Warning—Do not mount infusion pumps on the lower section of an IV pole. Interference with
head section articulation could result.
The Infusion Support System (ISS) consists of a movable and adjustable IV pole. The pole supports IV
pumps or bags in a vertical orientation and raises or lowers the pumps or bags with respect to the bed
frame.
The head end of the bed has attaching points for two mobile Infusion Support Systems. Each Infusion
Support System can support one infusion pump plus two liters of intravenous solution.
The ISS pole installs in to one of the IV pole sockets with the P7515A adapter kit.
The P158A ISS IV pole is a removable, two section telescopic pole that installs at the head end of the bed
into an adapter that snaps into the receiver holes. The IV pole can hold 20 lb (9 kg).
P7511A Permanent IV Pole X
P7514A IV Pole adapter kit (for P2217 IV pole) X
P7512B Line manager kit X
P7507A01/02/03/04 Caregiver Pendant Refer to “Caregiver Pendant
Controls” on page 25.
P7524A Transport Shelf X
P008712
b
Kinetec oxygen tank holder X
P752801/02/03 Head extension Refer to“Head Extension
(P752801/P752802/P752803)”
on page 98.
P7529 Proning kit Refer to “Proning Kit (P7529)”
on page 99.
P7546A01 Experience Pod Device (Overhead Arm) Refer to “Experience Pod
Device (Overhead Arm)
(P7546A01)” on page 101.
a. Requires adapter.
b. Available in select countries where type B5 (140 mm) cylinders are commonly used. Manufactured by
Kinetec.
Product Number Description
Usable Equipment Sockets
Head-End Foot-End