baxter Hillrom Progressa - Location Asset Tag; Internal Wireless Module; Smartcare Remote Management

Bed Frame Features
Hillrom Progressa ICU Hospital Bed Instructions for Use (171528 REV 15) 77
LOCATION ASSET TAG
Internal Wireless Module
The internal wireless module permits bed and surface data to be sent to a hospital’s information system
without a communication cable; the module does not communicate nurse call information or bed
location. (For electrical specifications, see page 133.)
SMARTCARE REMOTE MANAGEMENT
The SmartCare Remote Management is a secure cloud-based portal for centralized remote
management of Hillrom beds and devices. The SmartCare Remote Management gives the Biomedical
Engineers and/or Baxter Service Technicians access to manage devices remotely for the following
features:
•Remote update configuration
• Remote upgrade asset firmware
• Remote asset location tracking
• Remote error code notification
CAUTION:
To help prevent equipment damage, obey these
cautions:
• Caution—The Wireless Connectivity feature is
configured for the Hill-Rom approved Location
Asset tag. The location feature may not
operate correctly if you use a different asset
tag. Contact your local Baxter representative
for more information.
• Caution—Do not have other wireless devices
within 8" (20 cm) of the Location Asset Tag. If
their locations are too close, the devices may
not operate.
If installed, this tag is used along with the external wireless module option to identify the bed’s location
(refer to “Wireless Connectivity” on page 73).
For more information about the Location Asset Tag, refer to the manufacturer’s instructions included
with the tag.