Bed Frame Features
Hillrom Progressa ICU Hospital Bed Instructions for Use (171528 REV 15) 75
Some beds are equipped with an external wireless module, see below. The content below applies to the
external wireless module. For beds with an internal wireless module, see “Wireless Connectivity
Specifications—External Wireless Module” on page 129.
External Module Indicators
If the bed is receiving AC power, the initialization process is complete (at least 3 minutes have passed
since power was connected), and any of the indicators are red, there is a network connection issue. If
any of the indicators are off, there is a software issue. If either of these conditions occur, contact your IT
or Service department.
The table below identifies the different states of the indicators:
When you plug the bed into AC power, the module’s
three indicators—Wireless, Connected, and
Location—will all flash red, green, and off for two
cycles (this may take up to 30 seconds to occur). This
lets you know that the initialization process has
started. The module first connects to the facility’s
wireless network, then to SmartSync System, and then
to the RTLS. When the initialization process is
complete, each indicator will either be green or red
depending on its connection status (see the table
below). The indicators will stay on until AC power is
disconnected or an issue occurs with the module or its
connections.
It may take up to 3 minutes for the initialization
process to complete. During most of this time, the
indicators will be off.
Status
Flash red, green, and off The module is initializing.
Off Off Off The module either is not receiving AC power, is initializing, or is
in an error condition.
Red Red Red The module is not connected to the wireless network.
Green Red Red The module is connected to the wireless network, but is not
communicating with SmartSync System and can not identify
the bed’s location.
Green Green Red The module is connected to the wireless network and is com-
municating with SmartSync System, but can not identify the
bed’s location.
Green Green Green The module is connected to the wireless network, is communi-
cating with SmartSync System, and can identify the bed’s loca-
tion.
To Next Page
Loading...
